How to Install the NEW Over the Door
odoor56.2 Airstream Light.

For starters, if you have and 1156 socket "2006 and B4"

take the light lens off by removing the two screws.
If they are rusted you may want to use a penetrating oil to loosen them up.
Take the bulb out, incert the pigtail socket, push socket up out of the way,
pictured below .

Insert the new light.and sticking the taped
bracket to the top of the casting. The 3 bottom
pictures on this page show this step.

Then put the lens back into place.
You do NOT want to try to use this light without
the lens. The lens also may need to be trimmed to fit
your casting. Airstream has about 8 different size casting
over the years for all the different years of units. This lens should
fit all years of the castings with a little triming.

 

The picture below is what a T10 socket looks like. To use this kit you
will need to remove the T10 socket by drilling the rivet out,
or taking out the srew. The T10 socket has two wires. One is
a hot wire and one is the ground. The 1156 socket is grounded
by way of attaching the socket. Them all you need to do is attach the single
wire of the 1156 socket to the hot wire coming from your unit.

 

 

Then push the socket up out of the way to make room for the new light. (Pictured below)

Then put the light in place to made sure you have enough room and if the socket is far enough. Also
Make sure the light is far enough inside to allow the lens to go back into place.

We are using the pictures with the old light because the concepts are the same.

 

Now take the light back out and pull the tapes RED backing off and push upward. (see next two pictures)

 

 

Click here to see the odoor56.2 Pig tail light in our shopping cart